Tweet
I'm using the Woodies LSMA EFS and the pivots never display. I only get a message in the margin that says Pivot=no data. Can someone tell me how to adjust Esignal so I can get the pivots?
Ron
Ron
-
Ronald J. Alterman -
pivots
Make sure you have proper time frame set for chart. -
Rjalterman,
You may want to view the following eSignal Movie Clip regarding how to utilize and interact with Advanced Charts.Comment
-
Duane, the clip was for a standard chart, not an advanced chart. It had a short segment that had to do with time settings at the end, but I gathered from Woodies post, I had to make a time adjustment to my chart, so I'm not sure how the clip helps.
I played around with this a little bit and what happens is if I use a 5 minute chart and I add the 34 ema/24 lsma efs first, I get the pivots. If I add the CCI efs first, I get the 'pivot=no data ' message in the margin. I went into edit time template and both charts have 'equity rth west coast'. I set the charts up from scratch a couple of times to make sure it wasn't a fluke. I don't see what going on here, but in the mean time I can add the ma-efs first.
RonRonald J. AltermanComment
-
Hi Ron,
The link should be working ok now. I have seen the message you described before. It seemed to be something that was tied to an earlier version of the EFS that you are running. I would double check to insure that you are running the latest version of the LSMA EFS.Comment
Comment