SetStop in Formula Wizard

[yurips]

Hi, I'm learning the Formula Wizard by following the help file which describes building the "Three Bar Breakout" system. I like this example because it shows how to setup a backtest using the Formula Wizard.
When its time to set the stop the author is showing he set it to the low of the current bar. When I try SetStop only lets me key in a numeric value, not the Low or High.
I tried keying in Low() but it was converted to a large negative number.
The attachment shows where I'm at - how can I set it to low.
Thanks,
Yuri

[eSignal_JasonK]

Hello Yuri,

Rather than trying to enter the function in the Function Editor window, just type it in the main Formula Wizard window like in the example below.