Repeated crashing with V11 64b after a minute or so running.

[DCMGT]

No detailed error messages, just windows 7 says that the program caused an error and will be shut down after it tried to find a solution and could not. Dead in the water, programmer please address this ASAP.

[DCMGT]

Dead in the water

Is anyone out there from esignal to help? There must be an option to output crash info from the program that can be deciphered (??)

[JayF]

DCMGT,

We should be able to detect what happened. Please send over your username via Private Message, and we'll look for any crash reports we may have.

[DCMGT]

Crashing

Jay - Just sent ID and some info via PM. The problem appears to be correlated to how much data is displayed and calculations crunched on by the algorithm at one time. As the horizontal axis is compressed, such that more data points are gathered and calculations run, the crashing surfaces. It happens at time ranges well below what is required from a practical standpoint to do work. BTW, make sure to ignore the occasional crash reports from the Dec 1st v11 64b that I was running previously (those usually happened when starting the program and if you could get it past that point it would work fine for awhile). FYI, I have never seen the esignal crash report window for the Gold v11 64b problems, a windows notice of program malfunction comes up instead.